View 2K4S-P009_4468611.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

2400W Parallel (N+1) With PFC Function
SCP-2K4
series
Features : AC input 180~260VAC, 33 wire AC 220V, 1or 380V, 34 wire(option) PF> 0.98@ 230VAC Protections: Short circuit / Overload / Over voltage / Over temperature Built-in remote sense function, remote ON-OFF control Built-in power good signal output Built-in parallel operation function(N+1) Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan Case coating with paint 3 years warranty
..
SPECIFICATION
ORDER NO. SAFETY MODEL NO. DC VOLTAGE RATED CURRENT CURRENT RANGE RATED POWER OUTPUT VOLTAGE ADJ. RANGE LINE REGULATION LOAD REGULATION VOLTAGE RANGE FREQUENCY RANGE POWER FACTOR INPUT EFFICIENCY (Typ.) AC CURRENT INRUSH CURRENT (max.) LEAKAGE CURRENT(max.) OVERLOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE
Note. 4
SCP-2K4-09 2K4S-P009 9V 266A 0 ~ 266A 2394W
SCP-2K4-12 2K4S-P012 12V 200A 0 ~ 200A 2400W 120mVp-p
SCP-2K4-15 2K4S-P015 15V 160A 0 ~ 160A 2400W 150mVp-p
SCP-2K4-18 2K4S-P018 18V 133.3A 0 ~ 133.3A 2399W 150mVp-p
SCP-2K4-24 2K4S-P024 24V 100A 0 ~ 100A 2400W 150mVp-p
SCP-2K4-36 2K4S-P036 36V 66.6A 0 ~ 66.6A 2397W 200mVp-p
SCP-2K4-48 2K4S-P048 48V 50A 0 ~ 50A 2400W 200mVp-p
SCP-2K4-60 2K4S-P060 60V 40A 0 ~ 40A 2400W 200mVp-p 1.0% 0.5% 0.5%
RIPPLE & NOISE (max.) Note.2 90mVp-p
3.0% Typical adjustment by potentiometer 1.0% 1.0% VOLTAGE TOLERANCE Note.3 2.0% 0.5% 1.5% 180 ~ 260VAC 47 ~ 63Hz >0.98 / 230VAC 83% 15A / 230VAC 60A / 230VAC 3.5mA / 240VAC 110 ~ 140% rated output power 84% 85% 0.5% 0.5% 0.5% 0.5%
20% ~ 100% adjustment by 1 ~ 5VDC external control 1.0% 1.0% 1.0% 1.0% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5%
SETUP, RISE, HOLD UP TIME 800ms, 400ms, 12ms at full load 33 wire (other system available)
86%
88%
88%
89%
89%
Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover 110 ~ 135% Follow to output set up point Protection type : Shut down o/p voltage, re-power on to recover >100 / measure by heat sink, near transformer Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -20 ~ +65 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85, 10 ~ 95% RH 0.04% / (0 ~ 50) 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950, TUV EN60950-1 Approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC
SAFETY & ISOLATION RESISTANCE I/P-O/P, I/P-FG, OP/FG:100M Ohms / 500VDC / 25/ 70% RH EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) class A EMC (Note. 5) Compliance to EN61000-3-2,3 HARMONIC CURRENT EMS IMMUNITY POWER GOOD SIGNAL SPECIAL FUNCTION OTHERS COOLING MTBF DIMENSION PACKING NOTE Compliance to EN61000-4-2,3,4,5,6,8,11, Light industry level, criteria A Open collector of NPN transistor DC Voltage Adj., Remote sensing, remote control, parallel operation(refer to control terminal instruction manual) By fan, >20% load or >50 fan on 24.9K hrs min. MIL-HDBK-217F(25) 350*212*124mm (L*W*H) 9.0kg ; 1pcs / 10kg / CARTON
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Current limiting 3 times(1.5s,3.0s,5.0s)Then intelligent auto recovery before shut down 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.
File Name:SCP-2K4-SPEC 2007-03-01
2400W Parallel (N+1) With PFC Function
Mechanical Specification
SCP-2K4
series
Unit:mm
212[8.35]
332 [13.07]
8-M3X0.5 Terminal Block For Control Signal
1 23 45678 V-ADJ 1 2
5-M4X0.7 Terminal block For AC Input
34 5
123.9 [4.88]
Air flow direction
6-M6 SCREW FOR DC OUTPUT
POS(+)
LED 320 [12.60] 30 [1.18]
NEG(-)
6 [0.24] TYP
180[7.09]
4-M4X0.7 MOUNTING HOLE FOR USER 290 [11.42] 24 [0.94]
Control Terminal Pin. No. Assignment :
Pin No. 1 2 3 4 Assignment VS+ VSVCI VCO Pin No. 5 6 7 8 Assignment PG PAR GND INH
AC Input Terminal Pin. No. Assignment
Pin No. 1 2 3 Assignment FG N T Pin No. 4 5 Assignment S R
Derating Curve
Ta=25
100
80
OUTPUT POWER (W)
-10 10 20 30 40 50 60 70
2400 2000
LOAD (%)
60 40
1200
20
900
-20
90
110
150
170
260
AMBIENT TEMPERATURE ()
INPUT VOLTAGE (VAC) 60Hz
File Name:SCP-2K4-SPEC 2007-03-01
2400W Parallel (N+1) With PFC Function
Control terminal instruction manual
SCP-2K4
series
LOAD
LOAD
LOAD
LOAD
VS+ VSVCI VCO PG PAR GND INH
VS+ VSVCI VCO PG PAR GND INH
VS+ VSVCI VCO PG PAR GND INH
ON/OFF SWITCH
VS+ VSVCI VCO PG PAR GND INH
H:ON L:OFF
USING INTERNAL VOLTAGE CONTROL
REMOTE SENSING
ON/OFF CONTROL BY SWITCH
ON/OFF CONTROL BY TRANSISTOR
Vout
GOOD FAIL : LED OFF : LED ON O.V.P. 120% (Typ.)
120 100
LOAD LOAD
OUTPUT VOLTAGE (%)
80 60 40 20
Non-Linear
VS+ VSVCI VCO PG PAR GND INH
40V / 0.5A MAX.
VS+ VSVCI VCO PG PAR GND INH
DC 1-5V
POWER GOOD SIGNAL
OUTPUT VOLTAGE ADJUST WITH DC 1-5V
1
2
3
4
5
6
V
EXTERNAL VOLTAGE (DC)
LOAD
LOAD
VS+ VSVCI VCO PG PAR GND INH
VS+ VSVCI VCO PG PAR GND INH
VS+ VSVCI VCO PG PAR GND INH
VS+ VSVCI VCO PG PAR GND INH
VS+ VSVCI VCO PG PAR GND INH
VS+ VSVCI VCO PG PAR GND INH
PARALLEL OPERATION WITH REMOTE SENSING
PARALLEL OPERATION WITHOUT REMOTE SENSING
File Name:SCP-2K4-SPEC 2007-03-01
2400W Parallel (N+1) With PFC Function
FIG. A: 3 3W 220VAC SYSTEM (STANDARD MODEL FOR STOCK)
R R
SCP-2K4
series
L1 N1
FG1
220V
S
L2 N2
FG2
T S N (NC)
L3 N3
FG3
220V
FG T
FIG. B: 1
220VAC SYSTEM
L R L1 N1 S FG1
220V
L2 N2
FG2
T N
L3 N3
FG3
N
FG
FIG. C: 3
4W 220/380VAC SYSTEM
R R L1 N1
FG1
220V
S
L2 N2
FG2
T N N S FG
L3 N3
FG3
380V
T
FIG. D: 3
4W 190/110VAC SYSTEM
R R L1 N1 S N (N.C.) T L2 N2 L3 N3 N (NC)
110V
FG1
FG2
FG3
S
190V
FG T
File Name: SCP-2K4-SPEC 2007-03-01

▲Up To Search▲

Price & Availability of 2K4S-P009

	To Download 2K4S-P009 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .